For all you welders:
I am making a skid plate out of 3/8" plate. The piece was nice and flat when I started. I have welded some on one side of the plate. And now the plate is warped. The edges pulled up on the side that I was welding on. Can I flatten it out again by placing some beads on the opposite side? Getting a new piece of plate is not an option. I have too many hours in this one. Thanks for your suggestions.
Later,
4WheelDriveWeb
I am making a skid plate out of 3/8" plate. The piece was nice and flat when I started. I have welded some on one side of the plate. And now the plate is warped. The edges pulled up on the side that I was welding on. Can I flatten it out again by placing some beads on the opposite side? Getting a new piece of plate is not an option. I have too many hours in this one. Thanks for your suggestions.
Later,
4WheelDriveWeb