Off Roading Forums banner
1 - 2 of 2 Posts

Discussion Starter · #1 ·
Is there a yoke on a different t-case that will fit the rear output shaft of the Dana 20 so I can use a Cherokee CV driveshaft?


· Registered
261 Posts
When I swapped in a cv rear drive line in my CJ I had to buy a yoke. It was like $20 from Tom Woods, which was where i got the drive line also. You could try pulling your old rear output yoke off and counting the splines(some Dana 20's are diferent) and then matching it up with some junkyard outputs.

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.