Off Roading Forums banner
1 - 2 of 2 Posts
G

·
Discussion Starter · #1 ·
Can anyone tell me how to replace the balljoints in a .91 wrangler? Ihave been told that it is a dealer only job. Any info on tools needed and procedures would be helpful.

 
G

·
Discussion Starter · #2 ·
It requires a special extra large C-clamp type tool, with adapters to do it properly. Theyare available from the tool trucks that visit the garages every week. Any good suspension oriented shop should have at least one mechanic with the proper tools. If you don't mind spending around $250, find one of the tool trucks and purchase them yourself. With a service manual, and the proper tools, the job is easy. Good luck!


 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top