NEWS PARTS JEEP & 4x4 ATV & UTV

wipers

342 Views 4 Replies 4 Participants Last post by holsters, Mar 9, 2004

2770

Discussion Starter · Mar 9, 2004

OK. Did the search, no luck. Any one have an illustration on how to access and replace wiper linkages on a CJ? LEVE posted picture 1-14-03 but I couldn't open the picture. My linkages are worn enough to cause a delay at both ends of travel making a clunking noise as it re-engages and have recently started to bind. The previous owner glued an after market dash to the stock one that may have to be busted off to access the wiper motor.

Save

1 - 2 of 5 Posts

2770

Discussion Starter · #5 · Mar 9, 2004

Thanks guys. Once I got home and layed the wind shield over it was very simple. I was led to believe otherwise by a "local expert". It was so simple I was a little embarassed

to have asked the question. The wind shield frame is bent, no problem to straighted. Easy enough to cut key-way in washers to re-enforce. One of the staked on pivot arms is loose, I'll try to re-stake, if not I'll replace it. Thanks again.

See less See more

Save

1 - 2 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month