Off Roading Forums banner
1 - 1 of 1 Posts

·
Official Historian
Joined
·
8,340 Posts
It would be messy but you could put some gear oil on the frame above the broken bolts and let it make its way down to where you are drilling. Then just replenish the oil every minute or so. Might want to even use 140W so it flows down the frame slower to stay in place longer. Just pull your drill bit in and out to get the tip coated with oil again.

 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top