Off Roading Forums banner
1 - 2 of 2 Posts
G

·
Discussion Starter · #1 ·
I'm going to repack my wheel bearings on my '96 KC 4x4 this weekend. I was looking at my manual and it says to completely
remove the spindle? Why? It looks like you can get to both bearings by just removing the wheel hub from the rotor with the
spindle still attached. Any ideas or suggestions?

 
G

·
Discussion Starter · #2 ·
To answer my own question since nobody else did... you can get to both bearing easily without removing the spindle.

 
1 - 2 of 2 Posts
Top