[Guest]

I know the cons against welding the rear diffs. but I have two, I also want to save the dollars by not buying a locker. That being said I need pictures or someone able to describe exactly what it is I weld. I have removed the third member from the housing, but I can not figure out where to weld. can anyone help?
Thanks in advance.

 

[dparker]

remove your bearings and ring gear first! then you will see the best way i can describeit as bananna slots weld the crap out of them fill the holes copletly up then turn it over take the cover off weld the side gears up real good put hte cover back on and reasbley your ready to go!

RUN IN TO YOU LATER

 

[DougO]

What I did, was take the spiders out, carefully make sure the were properly lined up, then proceded to make them into basicly a mini spool, after that, since it wouldnt fit in to the carrier, I ground enough down so it would fit, then proceded to completly weld up just about everything I could making it to as much as a solid piece as possible.

 

[Guest]

Here is a pic of mine.

Wes.

http://albums.photopoint.com/j/AlbumList?u=1596164&f=0http://albums.photopoint.com/j/AlbumList?u=1596164&f=0