[jeepgod]

umm.. once again.. a u-joint is a u-joint.. it only gets stronger if it gets bigger.. they are limited to size.. so they can only make them so strong.. if you want stronger then you have to go bigger..
i would go with brute force just for the warranty.. you break it they give you another.. have gone thru 3 of them.. never had a problem..
besides.. you want to break u-joints... since they are 13 bucks.. vs. 200 bucks for your ring and pinion gears.. something has to be the weak link..

survival is instinct, but living takes guts

 

[jeepgod]

sorry ozark.. i had seen results from a test.. where they tested just about all major brands.. and they all broke at about the same point.. i mean they were plenty strong.. and i do agree that with proper care and correct angle.. it should be really hard to break one.. but i was just going by the test.. warn did the test.. i could probably find the results and post them here.. but who knows.. i didnt do it.. so i dont believe one hundred percent.. but they did the test.. because they were testing the new axle shafts they had made..
im sure there can be some difference in makes.. but i dont think it would still be that much of a difference.. and i also believe that they should break.. before something else does..


survival is instinct, but living takes guts