Off Roading Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
2,062 Posts
Sure - if you find a tube or pipe that have identical O.D. ......and assuming that all the material (read strength) aspects of the bender(s) are identical. So either order your tubing to match the O.D. of the pipe bender in question or order pipe in an O.D. to match the tubing bender. The metal supplier that you're buying it from should have tables that will give you all the info you need ......of course ......since they more than likely have it sitting around in one form or another ......take a caliper (or a ruler for that matter) to the place and see for yourself.
If you don't match the O.D. of the material with the groove on the bender you'll not get a smooth radius bend (read eggshaped- weaker).

GeeAea


Figures don't lie ....... but liars sure do figure.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top