Off Roading Forums banner
1 - 2 of 2 Posts

Discussion Starter · #1 ·
this is my frist post so dont give me a hard time . i have a 90 yj that will not lock into 4 wheel it does not seem to have any vacume at the front axle or at the transfer case i checked axle shift fork it works ok eng is 6 cyl 5 spd trans any help would be graet thanks


· Registered
6,355 Posts
/wwwthreads_images/icons/smile.gif It's probably a bit too far back to locate now, but there was a recent post on this very thing. As I recall, the solution was under the battery, where the vacuum hoses were deteriorated. Hopefully, your post will attract some guys who drive YJs and will give you the scoop. When you post, be sure to add moonguys/wwwthreads_images/icons/wink.gif/wwwthreads_images/icons/laugh.gif. You just make this mark like this[ and then type in wink, or laugh, or tongue, or whatever it requires, then make this mark] and the moonguy will appear. [moonguy] /wwwthreads_images/icons/laugh.gif

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.