Off Roading Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
378 Posts
Discussion Starter · #2 ·
PIC # 2 This is the picture of the cage outside of the vehicle. The back main hoop is the ZUK roll bar with approx 1" cut out of it on each side to allow the side bars to fit without touching the targa bar.

"Happiness is a Belt Fed Weapon!"
 

Attachments

· Registered
Joined
·
3,286 Posts
Looks like that was lots of fun to put in there! :>
How does it mount in the front and back. Can you get some pictures of the bolt mount locations?

thanks

later..

got zook?
http://www.geocities.com/bik3r
29x10.5x15 SS TSL *SX*, Calmini Header, SPOA, Lights, Dupicolor!
 

· Registered
Joined
·
378 Posts
Discussion Starter · #4 ·
The cage takes some shoehorning to get it in there. The rear main hoop shood be chopped about 1" to lower it to allow adequate clearance for the side bars, then you weld them to the main hoop. The front bars bolt to the floor with the base plates straddling the body mount on the underside of the vehicle, so when you drill your holes through the floor they catch the body mounts thus giving it a more secure to the frame connection. The cage doesnt more at all when driving down the road or trail thus far.

"Happiness is a Belt Fed Weapon!"
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top