I'm not sure if it is just me, but I can't see your attachments.
![]()
Chris
Chris
T-18 to V-6 bellhousing
It's finally mated. Cost a bit more than I planned but for the same money I could have had the 3 speed rebuilt so I think it will be worth it.
I had a tranny shop install the input shaft and new bearings seals etc.
Check the attachments (if they work this time) to see what I went through mounting it. The top 2 holes were close enough but I had to add some material to bolt the bottom 2. It ain't pretty but time will tell if my welds will hold. I'm betting it will be fine.
Al
![]()
I had a tranny shop install the input shaft and new bearings seals etc.
Check the attachments (if they work this time) to see what I went through mounting it. The top 2 holes were close enough but I had to add some material to bolt the bottom 2. It ain't pretty but time will tell if my welds will hold. I'm betting it will be fine.
Al
1 - 1 of 7 Posts
1 - 1 of 7 Posts
