Off Roading Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
263 Posts
Here is what it looks like. Just remove the transfer case shifter rubber boot inside the cab. Then remove the smaller rubber boot on top of the transfer case. Then push down and twist counter clockwise on the sheet metal cap (shown in picture) about 1/4 turn. Pull out the shifter shaft and look for or replace the Shifter Sheet (shown in the picture and looks like a large rubber washer).
Hope this helps.
Bobcat.



Beat It To Fit . . . . Paint It To Match /wwwthreads_images/icons/tongue.gif
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top