Off Roading Forums banner
1 - 5 of 5 Posts

· Registered
1,929 Posts
Discussion Starter · #1 ·
I need to know about the seat belt mount for shoulder harness belts. My '82 Scrambler doesn't have shoulder belts. I have a set of '85 CJ7 belts I was going to put on the Scrambler. Are they long enough? Can someone give me a detailed description of the mounting point on the roll bar. I would like to copy the factory setup as much as possible. I will fabricate a threaded sleeve that will be welded into the roll bar. How does this setup work with the half hard top? If anyone can give measurements, bolt sizes, picture, etc... That would be great.

1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.