Road whining

TRY PUTTING THE TRANSFER CASE IN LOW AND DRIVE IT IF THE NOISE CHANGES IT WILL BE THE PROB IF IT DOESN'T THE REAREND WILL BE

88 zuki,s/r,header,1600,locked in the rear and weber carb. with mitsu seats and 2"inch pipe
87 zuk spoa (new project)
IF GOD IS YOUR CO-PILOT SWAP SEATS

DOES IT CHANGE ANY IN DIFFERENT GEARS IF IT DOESN'T MAKE NOISE IN 4TH ITS THE TRANNY BUT WITH THE ON OFF GAS MAKING THE NOISE CHANGE SOUNDS LIKE REAR END OOOHH CR#P I WAS YELLING SORRY
QUENT

88 zuki,s/r,header,1600,locked in the rear and weber carb. with mitsu seats and 2"inch pipe
87 zuk spoa (new project)
IF GOD IS YOUR CO-PILOT SWAP SEATS

the bearing kit for the tranny is around 70 bucks from atc trans parts it comes with all 6 main bearings the needle bearing between the input and main shaft and both seals
and its not that bad of a job it helps to have a bearing puller but if your good you can us 2 big screw drives,a brass drift and a hammer

88 zuki,s/r,header,1600,locked in the rear and weber carb. with mitsu seats and 2"inch pipe
87 zuk spoa (new project)
IF GOD IS YOUR CO-PILOT SWAP SEATS