Off Roading Forums banner
1 - 2 of 2 Posts
G

·
Discussion Starter · #1 ·
Hey folks!

I'm going to be replacing one of the head bolts on my 85 CJ7/258 with a studded bolt. I read a few posts regarding a similar situation and it seemed that the prefered method was to simply remove and replace the one bolt--rather than loosening all of the bolts and then retorquing them all. I think that's the logical answer, but just wanted to get a few more opinions before I do this.

Thanks!
Chris

 
G

·
Discussion Starter · #2 ·
No problem at all, just make sure the motor is COLD, I mean like sitting all night.

Brad (from the 4 Wheeling center of the universe, 4 corners USA)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top