Off Roading Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
4,675 Posts
I made my own tool years ago, and it still works fine

I took a coathanger, cut of the straight rung on the bottom, bent one end at a very sharp anlge ( like a V with one side being about an inch, and the other the ful length)

and gronund a very sharp point on that short tip with a grinder...
then bend a little crook in teh other end just for a better handle..

works like a charm, costs 10 minutes...



ozarkjeep
1977 CJ5 looking for T18a and hardtop!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top