Off Roading Forums banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
Hi Guys just pulled my oil pan off old motor so i could have every thing ready to slap back together to keep down time to min.but this pan the windage tray \oil baffle has a crack in it. is it a big problem? or can i just mig it and go? once again your help is graetly welcome. thanks Bill

 

·
Registered
Joined
·
247 Posts
mig and run when i put a 1600 in i had to remove the baffle to mod the 1300 pan for the 1600 what i want to know is how it cracked was the pan hammer by a bolder?

88 zuki,s/r,header,1600,locked in the rear and weber carb. with mitsu seats and 2"inch pipe
87 zuk spoa (new project)
IF GOD IS YOUR CO-PILOT SWAP SEATS
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top