Off Roading Forums banner
1 - 2 of 2 Posts
G

·
Discussion Starter · #1 ·
Hey,

Has anyone done a swap with a NV-4500 and the stock case (NV-241 or whatever from the pickup) bolted to it? I haven't checked on output locations on the case, but it seems something like this might work. This would be going in a Scrambler so I'm not worried too much about length. If anyone has done this, or knows what model p.u.'s would be good donors, please let me know.

Andy

'81 CJ-8 258/T-18/D300

 
G

·
Discussion Starter · #2 ·
welp, the NV4500HD is used in Ram 2500HD and 3500 pickups....but the NV241 and 241HD transfer cases have the outputs for the front axle on the driver's side, and all Rams are drivers side Differential.

mike

Give me Jeep or Give me Death!!!

(Will trade functioning organs for CJ-7 or flatfender)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top