Off Roading Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,036 Posts
Re: NP231 won\'t disengage 4H! Help!

Check the front axle disconnect vent valve under the battery, and see if it is plugged. This won't allow the shift motor to pull back and release, and I believe that the switch for the light is controlled by the axle disconnect, and if it dosn't disconnect, the light will always be on. Also check that the vacuum harness is still hooked to the motor, you may have knocked it off while 4 wheelin.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top