Off Roading Forums banner
1 - 1 of 11 Posts

· Registered
633 Posts
I had a hard time with that too. What I did was drill a hole in an air hammer punch for a piece of steel wire about .060 " thick. I used the air hammer to drive the steel rod CAREFULLY on the end of the old seal. If you are very careful it will come loose. You must be sure you don't let the steel rod come in contact with the inner part of the seal groove when the old seal comes loose. Good luck.
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.