Off Roading Forums banner
1 - 1 of 2 Posts

· Registered
337 Posts
Discussion Starter · #1 ·
I was wondering how many ohms I should get when testing a tfi coil.
I got 8ohms on the secondary side and 0 on the primary side. Then I switched over to continuity on my meter and there is continuity between the + and - of the primary side. IS this normal. Thanks

88 YJ: TR upgrade and MC2100
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.