NEWS PARTS JEEP & 4x4 ATV & UTV

Need help locating parts

2343 Views 2 Replies 0 Participants Last post by suzukinutter, Aug 5, 2007

Discussion Starter · Jul 4, 2007

I'm looking at picking up a 1975 Land Rover, vin FJ40204730. I need some help locating parts. The driver's side running board is shot as well as both ambulance doors. The driver's side rear corner is rotted out & both sides have rot along the stripe. The rear floor is wood, but I think it should be metal. I'm trying to locate panels that I could weld in to replace the rotted stuff. All help will be greatly appreciated as this is my 1st restore since I was a teen. (54 now).
Thanks,
Papaw

Save

1 - 3 of 3 Posts

Discussion Starter · #2 · Aug 1, 2007

Used parts

I have tons of used Series parts and a baby on the way, so either the wife or some of my parts have to go. Email me what you need.

As far as new I prefer Rovers North, but everyone has their favorite.

Save

Discussion Starter · #3 · Aug 5, 2007

Papaw said:
I'm looking at picking up a 1975 Land Rover, vin FJ40204730. I need some help locating parts. The driver's side running board is shot as well as both ambulance doors. The driver's side rear corner is rotted out & both sides have rot along the stripe. The rear floor is wood, but I think it should be metal. I'm trying to locate panels that I could weld in to replace the rotted stuff. All help will be greatly appreciated as this is my 1st restore since I was a teen. (54 now).
Thanks,
Papaw

ok im engllish so i know im thick get me if im wrong you have a series 3 ambulance rear doors can be sourced over here yes the rear floor should be metal and what are running boards pic please? i might be able to get some bits from friends as i have 12 series l/rovers

Save

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month