Here is how I wired mine
![]()
MSD install question
My setup is a 82 CJ-7, I am replacing the stock 258 with a 401 with tfi upgrade. i want to incorporate a MSD 6A module. does this replace the stock duraspark module? The MSD instructions show two wires hooking into the factory coil connector then two wires going to the coil. Don't the wires from the factory coil connector come from the duraspark module?
Thanks
Max
Thanks
Max
1 - 2 of 7 Posts
If you follow the diagram above you can remove the stock duraspark module.
The green wire is negative for the coil, also used on some tachometers (not for use with a tach after MSD)
Yes you can use butt splices.
The green wire is negative for the coil, also used on some tachometers (not for use with a tach after MSD)
Yes you can use butt splices.
1 - 2 of 7 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Off Roading Forums
A forum community dedicated to all off road vehicle owners and enthusiasts. Come join the discussion about performance, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Recommended Communities
