Off Roading Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4,618 Posts
hey there..
yes go with the one piece axles, unless you will tow with your jeep. moser are ok.. but make sure you get timkin bearings with it and not the green ones. Just ask the salesman at moser they know what i am talking about. i myself have the one peace axles from 4wheel parts wholesalers.. not sure on manufacturer.. but they are great. have had them 3 years now.. and i am running a 401 with a t18 and 4.10 gears. if you go with the one peace axles make sure you get everything..ie. seals, bearings, shims (dont forget to shim the axle shafts) and retaining plates. keep in ming you will not be able to use regular jeep retaining plates for they must go over the end of the axle. one other hint.. weld your tubes to the axle housing all the way around.. they tend to spin under hard wheeling. later.. and good luck

 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top