Off Roading Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4,447 Posts
I made all of my JY mounts, for the D ring shackles. The 2 outside mounts have an open area in the middle to accept my tow bar mounts so I inserted hooks into the openings along with a D ring on the out side, it protects my tow bar mounts and gives a quick attachment point also. the inner mounts are just 1" thick steel welded to the front and back of the bumper connected with a 1/2" steel dowel, I had a structural welder, install these for me using a stick welder for good penetration. Here is a picture attachment. It works great for me.

Jeff
89 Wrangler
If at first you dont succeed, your replacement will try and try again.
 

Attachments

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top