NEWS PARTS JEEP & 4x4 ATV & UTV

Locking Hub on D30

647 Views 6 Replies 2 Participants Last post by **DONOTDELETE**, Jul 1, 2001

Discussion Starter · Jun 30, 2001

I am about to take the locking hubs apart to check the bearing in a wide track D30 going into a Jeepster. The problem is after I remove the five bolts that hold the hub and after removing the indicator screw with the unit in 2 wheel drive the locking hub will not come off.

Is it ok to pry it off with a screw driver? Or is there something wrong.

Save

1 - 1 of 7 Posts

294

· #5 · Jul 1, 2001

Mike is correct, it comes off in two parts, the snap ring is holding it in. Make shure you use lots of black RVT to seal the lockout hub back onto the axle hub, or you will be sorry. Also DO NOT PACK THE HUB WITH GREASE!!!! You will be sorry too. Ligtht grease, that is it.

John
Low rider 70 commando.
Parts an pieces to lots of ther Jeeps.

Save

1 - 1 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month