Off Roading Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
829 Posts
Discussion Starter · #1 ·
I Just tore the SideKick third member a part and I found there is no shims on either of the pinion's! Any one know why? Are the third members machined from the factory to be dead-on, or will I have to use shims on the pinion for the Samurai third member? Will the Pinion bearings from the SideKick fit the Samurai third member? Thanks:

Rodney C
Money Pit: 1985 CJ7 302 V8, T18, D20, D30, AMC20, SOA, Shackles Reversed, 35" BFG AT's, Fiberglass Tub & Front End, And, And, And.........
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top