Off Roading Forums banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
I have a edelbrock 304 torker manifold i just pulled off my jeep. It is only bored .030 so i really did not need it. If you have bored the piss out of your motor and need one i have one. Also, the wiper knob fell off and the switch is really hard to turn but it is also very sensitive. Can i just replace the knowb and solve these problems.

I enjoy working on friends four wheel drives but especially my own.
 
G

·
Discussion Starter · #2 ·
The Torker intake is not a good choice on a 304, it works well on a hot 390 or 401, 3500-7000 rpm, overkill on a smaller engine. The dealer still sells the factory knob, but aftermarket metal ones are available.

 
G

·
Discussion Starter · #3 ·
you can just buy a new wiper switch and knob from 4wd hardware for less than $20, replace the whole thing
1-800-333-5535.......
 
1 - 3 of 3 Posts
Top