Off Roading Forums banner
1 - 1 of 1 Posts

· Registered
546 Posts
Discussion Starter · #1 ·
Anyone had one of these go bad?
PCM good distributor and control module good
grounds and fusible links good
coil good injectors good
I have an open circuit from pin 4 on the PCM to the distributor and according to chiltons there is a resistor in that circuit.

It finally got nice enough to work on the damn thing so i decided on doing the heads.

Any ideas let me know.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.