Off Roading Forums banner
1 - 2 of 2 Posts
G

·
Discussion Starter · #1 ·
I am replacing my tired 258, and am looking at putting herculiner in the engine bay and firewall, but I am not sure about the conductive properties. any ideas or has anyone done this? I would hate to do the work then figure out I can't get a good ground. Thanks.

http://www.geocities.com/austnjpr/
 
G

·
Discussion Starter · #2 ·
You're right about grounding. You'll have to scrape away Herc with a flat head if you want a good ground. Herc will also hold grease and mud and whatever else gets on it due to the texture. If it were me I try something else.

 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top