Off Roading Forums banner
Cancel

How hard to remove body?

405 Views 8 Replies 5 Participants Last post by  tom3, 
G
As part of my Project SBC (putting in a Chevy Small Block), I am thinking of pulling the body off. I want to do a couple of suspension mods (traction bar, shocks, etc) as well as have better access to the fuel lines to install the electric fuel pump. Besides, it's time to replace the body bushings...getting kida old.

How hard is it?
Reply
Save
Like
1 - 1 of 9 Posts
S
When I replaced my steel body with a fiberglass one I found it to be pretty easy. Granted I took mine off in sections but i had to go through the motions of disconnecting everything. You could disconnect everything and just lift the body off the frame with 4 or so people put it to the side and have access to everything you want to work on, thats what I found to be the greatest part of owning a jeep.

Good Luck.
See less See more
Reply
Save
Like
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Off Roading Forums
A forum community dedicated to all off road vehicle owners and enthusiasts. Come join the discussion about performance, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
GM Standard IFS Trucks & SUV's Ford 67-96 F-Series, 78-96 Bronco General 4X4 and Off-Road New Member Introductions Tire Tips, What Works Best
Top