[Dirt Dog]

It's called www.shortwheelbase.com in the tech section. This is pretty awesome. They have blueprints on everything from bumpers to tire carriers to skid plates with all diamentions and measurements in PDF format. I thought this was pretty darn slick.
Just thought I'd share.........

 

[753]

I got the idea to relocate my rearmost body mounts to the bumper from that site a few months ago. For a rear crossmember, I used a piece of 3" channel and welded it between the framerails. The bumper is flush mounted to the channel and bolted through. The idea came from the pic below, although I opted to not use the frame mounts.

 

[13337]

Re: Have you guys heard of this site?......VERY CO

That's a nicely done piece of hardware there!

Good welding, very professional looking.
Good design too (consider it stolen!

I know a good idea when I steal it!).

You could work/ weld in a fabrication shop if everything else fails in life for you!
(That doesn't suck!)

 

[753]

Re: Have you guys heard of this site?......VERY CO

[ALU is glowing]

I wish that was the one I built - my welding is pretty close to that, but not perfect. I guess I wasn't clear in my earlier post, that's just where I got the idea from.

Thanks for the compliments though, just wish I could accept them!