Off Roading Forums banner
1 - 4 of 4 Posts
G

·
Discussion Starter · #1 ·
Alright, I have my new warn hubs on. Alot easier than I thought it would be! Ok, questions....

How tight should I titen the cap screws? It says 25-30 sq inch or whatever units they have it, but how tight it that? I dont havea torque wrench for allan wrench. Also.... was I supposed to lube it up in there or no?

Thanks!

 

·
Registered
Joined
·
1,545 Posts
I di mine probably a little tighter than that, but not too tight, not really sure how tight.....that was really useless....and no, your not supposed to put grease on them.

90K5
 
G

·
Discussion Starter · #3 ·
Ok, the one side had lots of lubricant in it, should I have cleaned it out??

So just snug up the little screws?

 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top