[527]

I have a 1980 T-176 and D-300 out of a CJ-5.This includes tranny,adapter,t-case and front and rear drive shafts.This is the short 300.The bell housing is not included,I need it for another project.I'm asking $350 for it all.I'll be using this money for a T-18,Dana 20 setup I've found.

F.T.D
77 CJ7,79 CJ5 Plow Jeep.

 

[527]

I don't want to seperate the setup because I don't want to get stuck with a tranny I can't use.I can always put the set up in my 79 CJ-5 for an upgrade.I'm located in Colebrook CT.

F.T.D
77 CJ7,79 CJ5 Plow Jeep.

 

[527]

Re: FS 1980 T-176 and DANA 300

B.T.T.

F.T.D
77 CJ7,79 CJ5 Plow Jeep.

 

[527]

Re: FS 1980 T-176 and DANA 300

I was cleaning up the T-176 tonight and the output shaft looks like it has a bit of wear on it,the splines are about half worn.The shifter on it needs the boot that holds the pins in,its torn and it also needs the cap that rides on the pins that holds the shifter in.I think those parts are about $15.00 from 4wd Hardware.The 300 has the strap type u-bolt hold downs and a couple of the bolts need to be drilled out but otherwise its ok.
On a differnt note how do you like your ZJ?I'm looking at a 94 myself and was wondering what kind of problems to look for.

F.T.D
77 CJ7,79 CJ5 Plow Jeep.

 

[527]

Re: FS 1980 T-176 and DANA 300

Neal,I need to have a shipping address,preferably a business address so I can find out how much the shipping will be for you.

F.T.D
77 CJ7,79 CJ5 Plow Jeep.