Off Roading Forums banner
1 - 5 of 5 Posts
G

·
Discussion Starter · #1 ·
What Chevy V6 Drivers Side Exaust Manifold has a front or center dump. I am doing a Vortec V6 conversion and both exhaust manifolds dump to the rear. The drivers side is right on top of the front driveshaft. I am wondering what would bolt up to the Vortec and dump to the center or to the front.

 

Attachments

G

·
Discussion Starter · #5 ·
One is cast, the other is stainless (one with the tube..) I had planned on using at least one of these on my 4.3L conversion, but I had problems with the passenger side, so I went with a set of shorty headers. If I used the stainless one, I had planned on cutting off the tube and having it welded closed (I don't have any stainless wire for my mig).

The cast one needs to have a spreader used when installing it, the back port bolt holes are off just a little. Supposedly this is common with cast manifolds.

Jim O'Brien
[email protected]
See my forsale list:
http://www.tidesys.com/forsale.htm
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top