Off Roading Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
271 Posts
Discussion Starter · #1 ·
Help! Need the rod journal spec on the big end where it connects to the crank. My Haines Manual gives about everything else, but doesn't list the rod journal size. We had to recon one rod, and want to make sure that we have it right before putting it together.
Any help is obviously appreciated. Thanks

Larry Robertson
88.5 Samurai-Under construction-always
90 Samurai-Under construction-always
97 Suzuki Sidekick Sport-Wife's ride
Way too much horsepower is barely enough!
 

·
Registered
Joined
·
219 Posts
Hey RamblinZuk:

Hope this is what you are looking for...

Crank pin diameter @ rod journal (standard) 41.982 - 42.000 mm (1.6529 - 1.6535 inches).

Let me know if this is not what you're looking for and I'll try harder.

 

·
Registered
Joined
·
352 Posts
wvn8v is right, it's on page 84 in my Haynes manual.

Why drive a luxo-box SUV when you can lay in the dirt busting your knuckles under old iron? '77 CJ-5, '64 S2A Land Rover
 
1 - 4 of 4 Posts
Top