Off Roading Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
6,842 Posts
Discussion Starter · #1 ·
This mass air kit off a lightning says it will work with a 5.8/e4od f150 but that seems unlikely to me:
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=1855741066

93 ECM from 5.8/e4od, $10:
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=1856066808

Chelsea 6-bolt PTO unit:
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=1856254478

Sterling 10.25" with spare parts, cheap!
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=1856348011

Braden PTO winch, 10k lbs:
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=1856588231

PTO winch gearbox, whatever that is... please explain to me?
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=1856617614

76 F150 rolling chassis, $50 right now:
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=1856947312

Dana 60 front, 10.25" rear off 95 f350, 4.10, $1500 takes it:
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=1856970093

that's all for now, hope this is of use to somebody
 

·
Registered
Joined
·
6,842 Posts
Discussion Starter · #5 ·
that's a good point! now we know why he's selling it


i dunno if anybody has realized this, but i was just at car-part.com and accidently asked for a front axle out of a f450/550, and those come with either 4.88 or 5.38 gears! man, that would be sweet to get a near-mint dana 60 (70?) and not even have to swap gears!
 

·
Registered
Joined
·
6,842 Posts
Discussion Starter · #6 ·
It's for a DODGE! I just looked up dodge 1 tons and that's the serial number for a dodge 3.54 front axle
Do those have CAD, cuz it looks like there is some metal structure attached to the axle on the left side of the zoomed out pic? I sent the guy a message noting that this is not a ford axle, i bet there's some bid retraction after that
 
G

·
the rear end in a 450 is a dana 80 with 1.50 axles and 37 splines and a 550 is a dana s135 with 1.72 with 36 spline and a 14.17 inch ring gear!
 

·
Registered
Joined
·
6,842 Posts
Discussion Starter · #8 ·
yeah the rear axle would be overkill, but the front should be just about right


apparently i am wrong, he emailed me back and said it certainly is a ford 02 axle... the serial numbers were similar because they are dana numbers, not ford or dodge assigned. the gear ratio is a mystery, but he said it has lockouts and a vac disconnect? is that true, why would they need both?
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top