Off Roading Forums banner
1 - 2 of 2 Posts

Discussion Starter · #1 ·
hey all,

I just got my 4:88 gears, Rear Spool, New hubs, and a lockright. I got a new carrier for the new gears and the question that i have is, Will the center pin from the stock carrier work in the new carrier?

Also, Do I need anything else besides the center pin? Will i Need those washers that sit behind the spiders? Can I use the stock ones, or no?


84CJ7 SOA,35's,OnboardAir,Dual winches,Full Cage,Snorkels, and more
OverMost 4WD Club
JerseyWheelers Club

· Registered
4,675 Posts
the pin should be the same

the washers can most likely be reused OR new ones should come in the gear install kit


"Bare foot girls, dancing in the moon light..."
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.