Off Roading Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
7,409 Posts
You can braze with propain but not weld. It's too "dirty".
Causes quite a bit of porosity. On the bright side you will not do a whole lot of OAW welding. Mostly cutting , heating(bending) , brazing. I doubt that you would weld anything structural with a torch. It will "bubblegum" it together w/ propain but the welds will be rather brittle.

I knew everything when I was 16......How come I'm so stupid now?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top