Off Roading Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
7,863 Posts
Discussion Starter · #1 ·

·
Registered
Joined
·
1,490 Posts
yeah from the pic they do look small but I wouldn't be surpised if they are at least 3/4ton axles. The front is probably a D44 and the rear almost looks like a 14boltSF because it is pretty flat on the bottom of the pumkin but its hard to tell from that distance.

93 GMC Yukon
Chevy SuperStock 4x4 Truck Puller
Great Lakes Truck & Tractor Pulling Association
http://www.greatlakespull.com
 

·
Registered
Joined
·
7,863 Posts
Discussion Starter · #4 ·
G

·
Look closely at the front end and where you think the front drive would go to. Hmmmm. I see the back one but no front. willyswanter I think your right.

 

·
Registered
Joined
·
1,471 Posts
This truck was avertised for sale a month or two ago. There is no front shaft, but the say one of those 80* double CV ones would work on it.

88 crewcab w/38's. For sale.
 

·
Registered
Joined
·
6,656 Posts
It was on Ebay a couple of months ago. The guys on the Toyota Truck forum of ORC were laughing their @sses off at it. I agreed with them. 1/2 ton axles too. UGLY!!!!!/wwwthreads_images/icons/shocked.gif Can someone say.......

SHOW TRUCK!

1992 Blazer Sport, 350 TBI, 4L60, 3" Flowmaster, K&N, MSD coil & wires, Rancho 2.5" lift, 285/75R16 AT's/wwwthreads_images/icons/laugh.gif
 
1 - 8 of 8 Posts
Top