Off Roading Forums banner
1 - 2 of 2 Posts
G

·
Discussion Starter · #1 ·
I have an amc 20 with the 12" brakes and they are ALL new. I just purchased a dana 44 rear and was wondering if my brakes will transfer to the dana.
 
G

·
Discussion Starter · #2 ·
Re: corp 20 to dana 44 rear end brake compatability question

While I can't say for sure, in my case, the brakes did transfer over without any problems. I swapped out my AMC 20 for a fullsize Dana 44 axle from an older International pickup truck. Drums, shoes, hardware was all interchangeable. Hopefully your swap will be the same.

1976 CJ-7
258ci, T18, Dana 20
6" Lift, Dana 44 Front & Rear
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top