Off Roading Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
827 Posts
Discussion Starter · #1 ·
Hi, I have one of those accel coils and there is no resistor. So basically there is 12 volts all the time. I was told it should drop off to 8 when running. Is this bad and if so how can I fix it? thanks Mike

Jeeps are Built not Bought
 

·
Registered
Joined
·
4,618 Posts
yes its bad.. you need a ballast resister... when you turn the engine over.. in the start position your coil should have around 10 or so volts.. then after it is started.. in the run position it should drop down to like 2-4 volts.. 12 volts constant will just burn up your coil way prematurely..

http://www.jeepgod.net

survival is instinct, but living takes guts
 
1 - 2 of 2 Posts
Top