The way I understand it is that everywhere you weld you change the heat treating of the metal making in more prone to cracking. This is probably acceptable for some reinforcement but not for initial manufacturing. It's best to have the frame mandrel bent for the offsets. Good Luck.
Posts by JimmyZ
1 - 1 of 1 Posts
1 - 1 of 1 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Join the discussion
Off Roading Forums
A forum community dedicated to all off road vehicle owners and enthusiasts. Come join the discussion about performance, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Recommended Communities
Join now to ask and comment!