Has anyone installed these on a 88-98 GM truck? I just ordered some for my Yukon, and wanted to know more about the install. What is the best way to cut, and any advice or tips on installing them? Thanks!
i put a set on a friends 89 about a month ago a saws all is about the best i tried a plasma cutter first but the inner and outer panels are to far apart make sure you cut down toward the the center mostly on the front so you dont take too much of the inner metal . watch where you place the screws if theyre too close to the flare the caps wont fit on
A forum community dedicated to all off road vehicle owners and enthusiasts. Come join the discussion about performance, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!