Off Roading Forums banner
1 - 4 of 4 Posts

Discussion Starter · #1 ·
I'm having problems busting shocks on my bump stops. Would removing the bump stops cause any problems? I really hate buying new shocks!

88 Samurai, 1300 bored .020,Power Punch II head w/1600 exhaust valves,Low End AAPA cam,Weber,Calmini Header,2" Exhaust System,31/13.50/15 Baja Belted Radials


Discussion Starter · #2 ·
If you remove your stops,bad things will happen to your springs (to much negative arch) You can build some new lower mounts to push the bottom of the shock out.Hope this helps....


· Registered
3,040 Posts
Yea keep the bumpstops or you will be reinstaling them or something new down the line. I just got the size of mine squared away, this so the front tires don't get cut on the fender well under full stuff. the rear I have no problems with. I just redid the bottom shock mounts so they are further back.

87' Zook Spoa,M/L 33's, 4.16 tcase,4.62 gears Camo,Header,2"exhuast, Cam.
Lockers, 8klb winch, -Wildweasel2 NE4WI- club
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.