Off Roading Forums banner

Brass Terminals/Distributor Cap

1853 Views 5 Replies 4 Participants Last post by  outlawmws
Just thought I would pass this along.....

I had recently replaced my dist. cap with one that had aluminum terminals (brass one wasn't available) with Bor Warner c605. If memory serves me correctly, that # used to be the "Select" cap that had brass terminals. It was shorly after I installed the cap that I started to get ignition noise in my stereo. PEP Boys no longer carries the Select cap, so I went to Napa and got #ECH EP685 that had brass terminals. Replaced the cap again Viola! No noise.....
My point is that the above Napa # is one for the dist. cap with brass terminals......
Hope this is of some help........
1 - 1 of 6 Posts
Crow:
Thanks for sharing the information.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top