Off Roading Forums banner
1 - 1 of 1 Posts
G

·
Discussion Starter · #1 ·
A friend replaced the seals on the wheel cylinders of his 86 S-10 and he says the wheel cylinders do not have the traditional grease fitting looking bleeders on them. Instead he says they have a setscrew looking plug without a way to loosen them.

Does anyone know how to bleed the brakes on these. is there a ball and spring inside the set screw looking thing that needs to be depressed?

How do you do it?

 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top