Off Roading Forums banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
Big Q\'s, please help guys!

1- How can you make a twin stick for the Dana 20?
2- Where can I find a place to build a heavy-duty highangle short c.v. driveshaft, it's going in a CJ-5 with a rear Dana 60 and a swapped in T-18.
3- The rear Dana 60 is out of a J-20 jeep truck and has 30 spline axle shafts, can I just get custom 35 spline shafts to fit in the rear with a new carrier or does it take anything else.
Thanks guys!
 

·
Registered
Joined
·
5,301 Posts
2

Try Six-States Distributors. They have a shop in Utah, and I guess 5 other states... :) I got an all new Spicer shaft with Spicer Gold U-joints spin-balanced to 7000RPM for my Bronco for $300 a few years ago. They advertise in most off-road magazines.
 

·
Registered
Joined
·
3,932 Posts
Re: Big Q\'s, please help guys!

I also got a CV driveshaft made by Six States for my YJ. I just measured center of u-joint to center of u-joint, and he made it perfect. Got a good deal on it too!
 
1 - 3 of 3 Posts
Top