Off Roading Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
I just ordered the Howell EFI kit (CA smog legal) for
my 84 CJ-7 258 4.2 which currently has the stock carb.
Does anyone have any tips, useful info, hints, etc.
regarding the installation of the fuel injection and/or
removal of the carb?

Thanks,
Chris Chang
[email protected]
 

·
Registered
Joined
·
13,432 Posts
Go out to Ted's site at Serria Jeep, he's got a good write up as well as a comparison of Howell to a MOPAR kit:

CLick here ========>

Then of course you can just click on my logo and look at my pathetic write up of on my Howell TBI install... Take your pick! Let me know if you need any help... been there.. done that! My word of advice... take the ECM's non-switched power off the oil gauge 12 volt feed. That's step Step W-10 in Ted's write up. This is about the only place on the Jeep that's not affected by the swipe of the igntion swtich.

 
1 - 2 of 2 Posts
Top